EDWARD EVERS | Robot Workshop | Hoverboard

Hoverboard

Introduction . How it works . Photos . Videos . Materials

Introduction

This project is both the evolution of a smaller scale version as well as a derivitive of the Nils Guadagnin hoverboard project. In this instance, care was taken to replicate the look of the hoverboard used by Marty McFly in the movie "Back to the Future Part II".

How it works

On the bottom of the hoverboard there is one floating disc attached near the front of the hoverboard and one attached near the rear of the hoverboard. The parts attached to the bottom of the hoverboard are actually a thin plactics layer that both hold the discs in place and replicate the look of the hoverboard used in the movie.

Imagine for a moment that you have two flat magnets, one lying south up on a table and the second held by the fingertips of you hands south down. The two magnets will repel each other when brought close together. You can simulate levitation by allowing the magnetic repulsion to determine the height of your magnet and by making tiny adjustments to the magnet you are holding (left-right, forward-backward).

The Crealev levitation pad uses electromagnets, instead of fingers, to accomplish the same levitation effect. The repulsion of the magnets determines the height, and the electromagnets keep the floating disc in place, with tiny adjustments left, right, forward, and backward.

Photos

Videos

Materials

The following materials are needed for this project

 EDWARD EVERS | Robot Workshop | Hoverboard

Modified 2011-11-01
Copyright © 2000-2011 Edward Evers